« Back

HmIP-CCU3

About

Hardware    : BCM2835
Model       : Raspberry Pi 3 Model B Rev 1.2

Install RaspberryMatic

download the latest ccu3 image from github and navigate to your CCU3 webui at Settings -> Control Panel -> CCU maintenance.

At CCU software select Choose File and follow the default firmware update procedure.

RaspberryMatic-${version}-ccu3.tgz (only for initial CCU3 Firmware -> RaspberryMatic Upgrade)

Configure wireguard

mkdir /usr/local/etc/config/wireguard
icd /usr/local/etc/config/wireguard

wg genkey | tee private.key | wg pubkey > public.key && chmod 0600 *.key
vim wg0.conf

Start wireguard

cat > /usr/local/etc/rc.local <<EOF
#!/bin/sh

ip link add wg0 type wireguard
ip addr add a.b.c.d/24 dev wgfin0
wg setconf wg0 /usr/local/etc/config/wireguard/wg0.conf 
ip link set wg0 up
# for each additional subnet listed in `AllowedIPs` a route needs to be set properly
ip route add x.y.z.0/24 dev wg0
EOF

chmod +x /usr/local/etc/rc.local

Option Address is not valid in wireguards Interface config section